Dell PowerConnect 8024 - Page 158

156 시작 안내서
www.dell.com | support.dell.com
1 단계 :
The system is not setup for SNMP management by default. To manage
the switch using SNMP (required for Dell Network Manager) you can
. Set up the initial SNMP version 2 account now.
. Return later and setup other SNMP accounts. (For more
information on setting up an SNMP version 1 or 3 account, see
the user documentation).
Would you like to setup the SNMP management interface now? [Y/N] y
To setup the SNMP management account you must specify the
management system IP address and the "community string" or
password that the particular management system uses to access the
switch. The wizard automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell Network
Manager or other management interfaces to change this setting and
to add additional management systems later. For more information
on adding management systems, see the User’s Guide.
To add a management station:
Please enter the SNMP community string to be used [public]:public
주: If it is configured, the default access level is set to the highest available access for the SNMP management
interface (이 항목이 구성될 경우 기본 액세스 레벨이 SNMP 관리 인터페이스에 사용할 수 있는 가
장 높은 액세스로 설정됩니다.) Initially only SNMPv1/2c will be activated (초기에는 SNMPv1/2c만 활성
화됩니다) SNMPv3 is disabled until you return to configure security access for SNMPv3 (e.g. engine ID, view,
etc.). (SNMPv3은 SNMPv3용 보안 액세스 구성으로 돌아갈 때까지 사용하지 않도록 설정됩니다
(예: 엔진 ID, view 등).
Please enter the IP address of the Management System (A.B.C.D)
or wildcard (0.0.0.0) to manage from any Management Station
{0.0.0.0}: 192.168.2.100