3. Keep the #2 Phillips screwdriver ready.
4. Remove the PCIe mezzanine card.
Steps
1. Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION: To prevent damage to the NDC, hold the card only by its edges.
2. Lift the card away from the system.
Figure 36. Removing the NDC
1. slot on the NDC 2. screw (2)
3. NDC 4. standoff (2)
5. connector 6. tab projections
Next steps
1. Install the NDC.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a PCIe mezzanine card
Installing the NDC
After working inside your system
105
To Next Page
Loading...
