Figure 64. Installing a 1.8-inch (x16) SAS SSD backplane
1. power cable 2. alignment pin
3. retention screw on the top of the
backplane (3)
4. backplane cable (2)
5. backplane cable connector that connects
to the connector on the expander card
6. backplane
7. guide pin (3) 8. backplane cable connector that
connects to the connector on the
system board
9. SSD cage
Next steps
1. Install the SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a 1.8-inch (x16) SAS SSD backplane
After working inside your system
Storage controller card
Your system includes dedicated expansion-card slots on the system board for a storage controller card
that provides the integrated storage subsystem for your system hard drives/PCIe SSDs. The storage
controller card supports SAS hard drives.
140
To Next Page
Loading...
