Dell PowerEdge M620 - Page 131

About Your System 131
The amount of
system memory has
changed.
Faulty memory module. See "Troubleshooting Blade
Memory" on page 319. If the
problem persists, see
"Getting Help" on page 361.
This system does
not support
processors greater
than 95W.
Unsupported processor(s)
installed.
Replace the processor(s)
with a supported version.
See "Processors" on
page 243.
Time-of-day clock
stopped.
Faulty battery; faulty blade
board.
See "Troubleshooting Blade
Memory" on page 319. If the
problem persists, see
"Getting Help" on page 361.
Time-of-day not
set — please run
SETUP program.
Incorrect Time or Date
settings; faulty blade board
battery.
Check the Time and Date
settings. See "Using the
System Setup Program
and UEFI Boot Manager" on
page 137. If the problem
persists, see
"Troubleshooting the
NVRAM Backup Battery" on
page 324.
Timer chip counter
2 failed.
Faulty blade board. See "Getting Help" on
page 361.
TPM failure A Trusted Platform
Module (TPM) function
has failed.
See "Getting Help" on
page 361.
Table 1-27. Blade Messages
(continued)
Message Causes Corrective Actions