334 System Board Information
PowerEdge M710 Jumper Settings
Figure 7-5
shows the location of the configuration jumpers on the blade
system board. Table 7-5 lists the jumper settings.
NOTE: Figure 7-5 is oriented with the front end of the blade system board facing to
the right.
Table 7-5. PowerEdge M710 Jumper Settings
PWRD_EN
(default) The password feature is enabled. (Pins 2-3)
The password feature is disabled. (Pins 1-2)
NVRAM_CLR
(default) The configuration settings are retained at
system boot. (Pins 4-5)
The configuration settings are cleared at the
next system boot. (Pins 5-6)
(If the configuration settings become corrupted
to the point where the system does not boot,
install the jumper and boot the system. Remove
the jumper before restoring the configuration
information.)
To Next Page
Loading...
