106
Figure 59. Installing the system board
1.
hex nut screw (4) 2.
system board
3. screw (10) 4.
system board handle
Next steps
1.
Install the following:
a.
Internal USB key
b.
SD vFlash card
c.
IDSDM or rSPI card
d.
NDC
e.
mezzanine cards
f.
PCIe extender or storage controller card
g.
Hard drive or SSD cage
h.
Hard drive or SSD backplane
i.
Hard drive(s) or SSD(s)
NOTE: Ensure that you reinstall the hard drives or SSDs in their original locations.
j.
Coolingshroud
k.
Memory modules
l.
Processor(s) and heat sink(s)
2.
Remove the plastic I/O connector covers from the back of the system.
To Next Page
Loading...
