108
After the restore process is complete, the system restarts.
Entering the system Service Tag by using System Setup
If Easy Restore fails to restore the Service Tag, use System Setup to enter the Service Tag.
1.
Turn on the system.
2.
Press F2 toenter System Setup.
3.
Click
Service TagSettings
.
4.
Enter the Service Tag.
NOTE: Youcanenterthe Service Tagonlywhenthe Service Tagfield isempty.Ensurethatyouenterthecorrect
Service Tag. After the Service Tag is entered, it cannot be updated or changed.
5.
Click
Ok
.
6.
Import your new or existing iDRAC Enterprise license.
For more information, see the
Integrated Dell Remote Access Controller User's Guide
at
Dell.com/idracmanuals
.
Trusted Platform Module
Trusted Platform Module (TPM) is a dedicated microprocessor designed to secure hardware by integrating cryptographic keys into
devices. A software can use a Trusted Platform Module to authenticate hardware devices. As each TPM chip has a unique and
secret RSA key burned in as it is produced, it can perform the platform authentication.
CAUTION: Do not attempt to remove the Trusted Platform Module (TPM) fromthe systemboard. Afterthe TPMis
installed, it is cryptographically bound to that
specific
system board. Any attempt to remove an installed TPM breaks the
cryptographic binding, and it cannot be re-installed or installed on another system board.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be performed only by Dell
certified
service technicians.
Installing the Trusted Platform Module
Prerequisites
CAUTION: Many repairs may only be done by a
certified
service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
1.
Followthesafetyguidelineslistedinthe Safetyinstructions section.
2.
Followthe procedure listed in the Beforeworking inside yoursystem section.
Steps
1.
Locate the Trusted Platform Module (TPM) connector on the system board.
NOTE: To locate the TPM connector on the system board, see the System board connectors section.
2.
Align the edge connectors on the TPM with the slot on the TPM connector.
3.
Insert the TPM into the TPM connector such that the plastic bolt aligns with the slot on the system board.
4.
Press the plastic bolt until the bolt snaps into place.
To Next Page
Loading...
