Dell PowerEdge M630 - Removing a Processor

81
Steps
1. Loosen the first screw that secures the heat sink to the system board.
Allow some time (around 30 seconds) for the heat sink to loosen from the processor.
2. Loosen the screw that is diagonally opposite the screw youfirst removed.
3. Repeat the procedure for the remaining two screws.
4. Remove the heatsink.
NOTE: Set the heat sink upside down on the work surface to avoid contaminating the thermal grease.
Figure 33. Removing a heat sink
1. retention screw (4) 2. heat sink
3. processor socket 4. heat sink retention socket (4)
Next steps
1. Replace the heat sink(s) and processor(s).
2. Followthe procedure listed inthe After working inside your system section.
Related links
Safety instructions
Before working inside your system
After working inside your system
Removing the cooling shroud
Installing a heat sink
Installing a processor
Removing a processor
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is
necessary to maintain proper thermal conditions.