Dell PowerEdge M630 - rSPI Card (Optional)

73
CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
Steps
1. Align the following:
• The slot on the card edge with the projection tabs on the mezzanine card support.
• The two screw holes on the IDSDM card with the standoffs on the system board.
• The hole on the SD card slot bracket with the screw hole on the IDSDM card.
2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.
Figure 26. Installing the optional IDSDM card
1. IDSDM card 2. screw (2)
3. SD card slot bracket 4. mezzanine card support bracket
5.
Next steps
IDSDM card connector on the system board 6. standoff (2)
1. If applicable, install the SDcard(s)and the internal USB key.
2. Followthe procedure listed inthe After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the optional IDSDM card
Replacing the internal USB key
After working inside your system
rSPI card (optional)
rSPI (restoreSerial Peripheral Interface) is a SPI flash device to store information about the system Service Tag,system
configuration, or iDRAC license.