Dell PowerEdge M630 - Installing the Network Daughter Card

79
Installing the Network Daughter Card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
NOTE: You must remove the NDC to replace a faulty NDC card or service other components inside the system.
CAUTION: Toprevent damage to the NDC, you must hold the card only by its edges.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Remove the mezzanine card.
4. Remove the NDC.
Steps
1. Align the following:
a. The slots on the card edge with the projection tabs on the plastic bracket covering the mezzanine card slots.
b. Screw holes on the card with the standoffs on the system board.
2. Lower the card into place until the card connector fits into the corresponding connector on the system board.
3. Secure the card with the two screws.
Figure 32. Installing the Network Daughter Card
1. slot on the NDC 2. screw (2)
3. NDC 4. standoff (2)
5. connector 6.
tab projections