Dell PowerEdge M630 - Removing the Optional rSPI Card

74
Removing the optional rSPI card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Followthe procedure listed in the Beforeworking inside yoursystem section.
Steps
1. Remove the two screws securing the rSPI card to the system board.
CAUTION: Toprevent damage to the rSPI card, you must hold the card only by its edges.
2. Lift the card up and away from the system.
Figure 27. Removing the optional rSPI card
1. screw (2) 2. rSPI card
3. standoff (2) 4. connector
Next steps
1. Install the rSPI card.
2. Followthe procedure listed inthe After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing the optional rSPI card
After working inside your system