Dell PowerEdge M630 - Installing a Processor or DIMM Blank

57
Figure 14. Removing a processor or DIMM blank
1. processor or DIMM blank 2. heat sink retention socket (4)
3. standoff (4)
Next steps
1. Install the processor and the heat sink.
2. Ensure that you install the processor or DIMM blank when you have removed a processor permanently.
3. Followthe procedure listed inthe After working inside your system section.
Related links
Safety instructions
Installing a processor
Installing a processor or DIMM blank
Before working inside your system
After working inside your system
Installingaprocessoror DIMMblank
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
NOTE: Youmust remove processor or DIMM blank when installing two processors or to serviceother components inside
the system.
1. Follow the safety guidelines listed in safety instructions section.
2. Followthe procedure listed in the Beforeworking inside yoursystem section.
3. Your system does not have processor or heat sink installed.
Steps
1. Align the standoffs on the processor or DIMM blank with the heat sink retention sockets on the processor socket.
2. Lower the processor or DIMM blank onto the system until the standoffs on the processor or DIMM blank engages with the heat
sink retention sockets.