80
Next steps
1.
Install the mezzanine card.
2.
Followthe procedure listed inthe After working inside your system section.
Related links
Safety instructions
Removing the mezzanine card
Removing the Network Daughter Card
Installing the mezzanine card
After working inside your system
Processors
Your system supports one or two Intel Xeon E5-2600 v3 or E5-2600 v4 product family processors.
CAUTION: For processors of 105 W, 120 W, or 135 W, use heat sinks of 68 mm width.
CAUTION: For processors of 105 W (for acoustic
configuration),
135 W (four cores, six cores, or eight cores), or 145 W,
useheatsinksof 104 mmwidth.
NOTE: Mixing processors of
different
wattages is not supported.
Use the following procedure when:
•
Removing and installing a heat sink
•
Installing an additional processor
•
Replacingaprocessor
NOTE: Toensurepropersystemcooling, youmustinstallaprocessorblankinanyemptyprocessorsocket.
Related links
Removing a heat sink
Removing a processor
Installing a processor
Installing a heat sink
Removing a heat sink
Prerequisites
CAUTION: Many repairs may only be done by a
certified
service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is
necessary to maintain proper thermal conditions.
NOTE: The processor and heat sink can become extremely hot. Be sure the processor has had
sufficient
time to cool
before handling.
1.
Follow the safety guidelines listed in safety instructions section.
2.
Keep the Phillips #2 screwdriver ready.
3.
Followthe procedure listed in the Beforeworking inside yoursystem section.
4.
Remove the cooling shroud.
To Next Page
Loading...
