Dell PowerEdge M630 - Installing the Optional IDSDM Card

72
Figure 25. Removing the optional IDSDM card
1. IDSDM card 2. screw (2)
3. SD card slot bracket 4. mezzanine card support bracket
5.
Next steps
IDSDM card connector on the system board 6. standoff (2)
1. Install the IDSDM card.
2. Followthe procedure listed inthe After working inside your system section.
Related links
Safety instructions
Installing the optional IDSDM card
Before working inside your system
Replacing the internal USB key
Replacing an SD card
After working inside your system
InstallingtheoptionalIDSDMcard
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructionsthatcamewiththeproduct.
NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other components inside the system.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Remove the SD card.
4. Remove the IDSDM card.