44
Related links
System Profile Settings
Viewing System Profile Settings
Miscellaneous Settings
Youcan use the Miscellaneous Settingsscreen to perform specific functions such as updating the asset tagandchanging the
system date and time.
Related links
Miscellaneous Settings details
System BIOS
Viewing Miscellaneous Settings
Viewing Miscellaneous Settings
To view the
Miscellaneous Settings
screen, perform the following steps:
1.
Turn on, or restart your system.
2.
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to
finish
booting, and then
restart your system and try again.
3.
On the System Setup Main Menu screen, click System BIOS.
4.
On the
System BIOS
screen, click
Miscellaneous Settings
.
Related links
Miscellaneous Settings
Miscellaneous Settings details
Miscellaneous Settings details
The
Miscellaneous Settings
screen details are explained as follows:
Option Description
System Time Enables you to set the time on the system.
System Date Enables you to set the date on the system.
Asset Tag Specifies the asset tag and enables you to modify it for security and tracking purposes.
Keyboard NumLock Enables you to set whether the system boots with the NumLock enabled or disabled. This option is set to
On by default.
NOTE: This option does not apply to 84-key keyboards.
F1/F2 Prompt on
Error
Load Legacy Video
Option ROM
In-System
Characterization
Enables or disables the F1/F2 prompt on error. This option is set to Enabledby default. The F1/F2 prompt
alsoincludeskeyboarderrors.
Enables you to determine whether the system BIOS loads the legacy video (INT 10H) option ROM from the
video controller. Selecting Enabled in the operating system does not support UEFIvideo output standards.
This field is available only for UEFI boot mode. You cannot set the option to Enabled if UEFI Secure Boot
mode is enabled.
Enables or disables
In-System Characterization
. This option is set to
Disabled
by default. The two other
options are
Enabled
and
Enabled - No Reboot
.
NOTE: The default setting for In-System Characterization is subject to change in future BIOS
releases.
When enabled, In-System Characterization (ISC) executes during POST upon detecting relevant change(s)
in system configuration to optimize system power and performance. ISCtakes about 20 seconds to execute,
To Next Page
Loading...
