Table 86. Expansion card riser configurations (continued)
PCIe
slot
With
Regular
shroud
R2A R3A R2P R3P R1P R4P R2Q R3P R2S R3S
Half
length
Slot 3
Low
profile -
Half
length
- x16 LP -
x16 LP
(Gen5)
- - -
x16 LP
(Gen5)
-
x16 LP
(Gen5)
Table 87. PCIe Riser Configs
Config # RSR
Configu
ration
# of
CPUs
PERC
type
support
ed
Rear
Storage
Possible
x16 CPU 1
Slot1 LP
x16 CPU 2
Slot2 LP
x16 CPU 2
Slot3 LP
x16 CPU 1
Slot1 FH
x16 CPU 2
Slot2 FH
0 No RSR 2 Front
PERC
No 0 0 0 0 0
1 R2A+R3
A
2 Front
PERC
No 1 1 1 0 0
2 R2P+R3
P
2 Front
PERC
No 1 1 1 0 0
3 R1P+R4P 2 Front
PERC
No 0 0 0 1 1
4 R2Q 2 Front
PERC
No 1 1 0 0 0
5 R3P 2 Front
PERC
Yes 0 0 1 0 0
6 R2S+R3
S
2 Front
PERC
Yes 1 0 1 0 0
7 R2A 1 Front
PERC
No 1 0 0 0 0
8 R2A+
R4-E3
Paddle
card
2 Front
PERC
No 1 1 0 0 0
9 R2A+R4
SCM G5
x 4
Paddle
card
2 Front
PERC
No 1 1 0 0 0
NOTE: The expansion-card slots are not hot-swappable.
The following table provides guidelines for installing expansion cards to ensure proper cooling and mechanical fit. The expansion
cards with the highest priority should be installed first using the slot priority indicated. All the other expansion cards should be
installed in the card priority and slot priority order.
Table 88. Config0. No RSR
CARD TYPE SLOT PRIORITY MAXIMUM NUMBER OF CARDS
FOXCONN (Front PERC) Integrated slot 1
FOXCONN (Front PERC) Integrated slot 1
Inventec(LOM Card) Integrated slot 1
Installing and removing system components 127
To Next Page
Loading...
