2. Install the air shroud.
3. Follow the procedure listed in After working inside your system.
4. To verify that the memory module has been installed properly, press F2 during reboot and navigate to System Setup Main
Menu > System BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the
updated capacity of the installed memory.
5. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Shut down the
system and ensure that the memory modules are firmly seated in the correct sockets.
6. Run the system memory test in system diagnostics.
Expansion cards and expansion card risers
NOTE: When an expansion card is not supported or missing, the iDRAC and Lifecycle Controller logs an event. This does
not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals.
Expansion card installation guidelines
Figure 82. Riser connector location on system board and PEM board
1.
Riser 4 slot 2. Riser 1 slot
3. Riser 2 cable slot 4. Riser 2 cable slot
5. Riser 4 cable slot 6. Riser 3 cable slot
7. Riser 3 cable slot 8. Riser 1 cable slot
NOTE: A riser can be connected to the riser slot or riser cable slot or both depending on the type of riser used.
122 Installing and removing system components
To Next Page
Loading...
