Cable routings
Figure 52. Configuration 0: 8 x 2.5-inch (SAS4/SATA)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 68. 8 x 2.5-inch (SAS4/SATA)
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SL4_CPU1_PA3 (signal connector on system board) CTRL_DST_PA1 (fPERC controller connector)
92 Installing and removing system components
To Next Page
Loading...
