Figure 53. Configuration 1: 16 x 2.5-inch (SAS4/SATA) with fPERC 11
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 69. 16 x 2.5-inch (SAS4/SATA) with fPERC 11
Order From To
1 CTRL_SRC_SB1 (fPERC controller Connector) BP_DST_SA1 (backplane signal connector)
2 SL4_CPU1_PA3 (signal connector on system board) CTRL_DST_PA1 (fPERC controller connector)
3 SIG_PWR_2 (system board power connector) BP _PWR_1 (backplane power connector)
4 SIG_PWR_1 (system board power connector) BP _PWR_1 (backplane power connector)
Installing and removing system components 93
To Next Page
Loading...
