Figure 54. Configuration 2: 16 x 2.5-inch (SAS4/SATA) with fPERC 12
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 70. 16 x 2.5-inch (SAS4/SATA) with fPERC 12
Order From To
1 CTRL_SRC_SB1_PB1 (fPERC controller connector) BP_DST_SA1 (backplane signal connector)
2 SL4_CPU1_PA3 (signal connector on system board) CTRL_DST_PA1 (fPERC controller connector)
3 SL5_CPU1_PB3 (signal connector on system board) CTRL_DST_PB1 (fPERC controller connector)
4 SIG_PWR_2 (system board power connector) BP_PWR_1 (backplane power connector)
5 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
6 CTRL_SRC_SA1_PA1 (fPERC controller connector) BP_DST_SA1 (backplane signal connector)
94 Installing and removing system components
To Next Page
Loading...
