Figure 55. Configuration 3: 16 x 2.5-inch (SAS4/SATA) + 8 x 2.5-inch NVMe with fPERC 11
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 71. 16 x 2.5-inch (SAS4/SATA) + 8 x 2.5-inch NVMe with fPERC 11
Order From To
1 CTRL_SRC_SB1 (fPERC controller connector) BP_DST_SA1 (backplane signal connector)
2 SL4_CPU1_PA3 (signal connector on system board) CTRL_DST_PA1 (fPERC controller connector)
3 SL3_CPU2_PA2 (signal connector on system board) DST_PA2 (backplane signal connector)
4 SL6_CPU1_PA4 (signal connector on system board) DST_PB2 (backplane signal connector)
5 SIG_PWR_2 (system board power connector) BP_PWR_1 (backplane power connector)
6 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
7 SIG_PWR_3 (system board power connector) BP_PWR_1 (backplane power connector)
8 SL14_CPU4_PA2 (signal connector on PEM) DST_PA1 (backplane signal connector)
9 SL17_CPU3_PA4 (signal connector on PEM) DST_PB1 (backplane signal connector)
Installing and removing system components 95
To Next Page
Loading...
