Figure 56. Configuration 4: 16 x 2.5-inch (SAS4/SATA) + 8 x 2.5-inch NVMe with fPERC 12
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 72. 16 x 2.5-inch (SAS4/SATA) + 8 x 2.5-inch NVMe with fPERC 12
Order From To
1 CTRL_SRC_SB1_PB1 (fPERC controller connector) BP_DST_SA1 (backplane signal connector)
2 SL4_CPU1_PA3 (signal connector on system board) CTRL_DST_PA1 (fPERC controller connector)
3 SL5_CPU1_PB3 (signal connector on system board) CTRL_DST_PB1 (fPERC controller connector)
4 SL3_CPU2_PA2 (signal connector on system board) DST_PA2 (backplane signal connector)
5 SL6_CPU1_PA4 (signal connector on system board) DST_PB2 (backplane signal connector)
6 SIG_PWR_2 (system board power connector) BP _PWR_1 (backplane power connector)
7 SIG_PWR_1 (system board power connector) BP _PWR_1 (backplane power connector)
8 SIG_PWR_3 (system board power connector) BP _PWR_1 (backplane power connector)
9 CTRL_SRC_SA1_PA1 (fPERC controller connector) BP_DST_SA1 (backplane signal connector)
10 SL1_4 _CPU4_P A2 (signal connector on PEM) DST_PA1 (backplane signal connector)
11 SL17_CPU3_PA4 (signal connector on PEM) DST_PB1 (backplane signal connector)
96 Installing and removing system components
To Next Page
Loading...
