NOTE: The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port.
NIC port specifications
The PowerEdge R860 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports embedded on
the LAN on Motherboard (LOM) and integrated on the optional Open Compute Project (OCP) cards.
Table 18. NIC port specification for the system
Feature Specifications
LOM card (optional) 1 GbE x 2
OCP card (OCP 3.0) (optional) 1GbE x 4, 10 GbE x 2, 10 GbE x 4, 25 GbE x 2, 25 GbE x 4
NOTE: The system allows either LOM card or an OCP card or both to be installed in the system.
Serial connector specifications
The PowerEdge R860 system supports one optional card type serial connector, which is a 9-pin connector, Data Terminal
Equipment (DTE), 16550-compliant.
The optional serial connector card is installed similar to an expansion card filler bracket.
VGA ports specifications
The PowerEdge R860 system supports DB-15 VGA port on front panel and on rear I/O board (optional for Direct Liquid Cooling
configuration).
Video specifications
The platform supports the following video resolution and refresh rates:
Table 19. Video specifications for R860
Resolution Refresh rate
(Hz)
Sestotal Freq. Pixel Clock DVO DisplayPort
1024 x 768 60 Hz 48.4 kHz 65.0 MHz Yes*
1280 x 800 60 Hz 49.7 kHz 83.5 MHz Yes*
1280 x 1024 60 Hz 64.0 kHz 108.0 MHz Yes*
1360 x 768 60 Hz 47.71 kHz 85.5 MHz Yes*
1440 x 900 60 Hz 55.9 kHz 106.5 MHz Yes*
1600 x 900 60 Hz 55.54 kHz 97.75 MHz Yes*
1600 x 1200 60 Hz 75.0 kHz 162.0 MHz Yes*
1680 x 1050 60 Hz 64.7 kHz 119.0 MHz Yes*
1920 x 1080 60 Hz (RB)^ 67.158 kHz 173.0 MHz No
1920 x 1200 60 Hz (RB) ^ 74.556 kHz 193.25 MHz No
*DVO - DP is for investigation only, dependent on Nuvoton DVO capabilities to support up to 165 MHz.
^(RB) - Reduced Blanking for Digital Displays requiring less blank time. It was introduced for Signal Integrity improvements by
reducing Pixel Clock rates for VGA- Analog input devices.
32
Technical specifications
To Next Page
Loading...
