Before you begin the installation or removal process, follow the safety guidelines and before working inside the system
instructions.
Table 97. BOSS-N1 module kit components
Components in kit R860 (quantity)
BOSS-N1 controller card module 1
BOSS-N1 card carrier 1 or 2*
M.2 NVMe SSD 1 or 2*
M.2 NVMe SSD capacity label 1 or 2
†
BOSS-N1 card carrier blank 1
M3 x 0.5 x 4.5 mm screws 1
BOSS-N1 power cable 1
BOSS-N1 signal cable 1
NOTE: *The quantity depends on the purchase order.
NOTE:
†
The quantity depends on the BOSS-N1 card carrier
To remove the BOSS blank :
1. Power off the system and remove the system cover.
2. Use a screwdriver to push out the blank from the BOSS-N1 module bay.
Figure 170. Removing the BOSS-N1 module blank
Upgrade Kits
199
To Next Page
Loading...
