Dell PowerEdge T30 - Page 26

Option Description
• Device Information
Boot Sequence
Specifies the list of devices, in which the system checks for an operating system to install in the
sequence of the listed devices. You can modify the sequence, if necessary. The available devices
are:
• Diskette Drive
• USB Storage Device
• CD/DVD/CD-RW Drive
• Onboard NIC
• Internal hard drive(s)
NOTE: The Diskette Drive option refers to the USB floppy drive.
Boot List Options Specifies the boot options. The available options are:
• Legacy
• UEFI
Advanced Boot Options Allows you to Enable Legacy Option ROMs. The available options are:
• Enable Legacy Option ROMs
• Enable Attempt Legacy Boot
By default, the Enable Legacy Option ROMs option is enabled.
Date/Time Allows you to set the date and time on the system. The changes to the system date and time takes
effect immediately.
Table 23. System configuration
Option Description
Integrated NIC Allows you to configure the integrated network controller. The available options are:
• Enable UEFI Network Stack
• Disabled
NOTE: You can use the Disabled option, only if Active Management Technology
(AMT) option is disabled.
• Enabled
• Enabled w/PXE
By default, the Enabled w/PXE option is selected.
Serial Port Identifies and defines the serial port settings. You can set the serial port to:
• Disabled
• COM1
• COM2
• COM3
• COM4
NOTE: The operating system may allocate resources even if the Serial port setting is
disabled.
By default, the COM1 option is selected.
SATA Operation Allows you to configure the internal SATA hard-drive controller. The available options are:
26 System Setup