Figure 112. Installing the 2.5-inch drive backplane
Ne
xt steps
1. Install the drives.
2. Connect the drive backplane cables to the connector on the backplane.
3. Install the cooling fan cage.
4. Install the front PERC module.
5. Follow the procedure listed in After working inside your system.
Drive bays
Removing the drive bay blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Remove the system cover.
3. If installed, remove the front bezel.
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the drive bay blank to the system.
2. Using a flat head screwdriver, remove the drive bay blank.
NOTE: The procedure to remove the drive bay blanks are similar.
164 Installing and removing system components
To Next Page
Loading...
