Figure 111. Removing the 2.5-inch drive backplane
Ne
xt steps
Replace the 2.5-inch drive backplane .
Installing the 2.5-inch drive backplane
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Remove the cooling fan cage.
4. Remove the drives.
5. Remove the front PERC module
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. A
lign the guides on the system with the slots on the backplane.
2. Insert the backplane into the guides and lower the backplane until the blue release stand-off clicks into place.
Installing and removing system components 163
To Next Page
Loading...
