88 Installing System Components
Figure 3-5. Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1
Align the cooling shroud with the alignment guides in the system.
2
Carefully lower the cooling shroud into the system until the securing tab
snaps over the shroud using the tab projection on the shroud as a
guidance. Ensure that no cables are pinned under the edges of the cooling
shroud.
3
Close the system. See "Closing the System" on page 86.
4
Place the system upright and on its feet on a flat, stable surface.
5
Rotate the system feet outward.
6
Reattach any peripherals, then connect the system to the electrical outlet.
7
Turn on the system and attached peripherals.
1 cooling shroud 2 cooling shroud release tab
1
2
book.book Page 88 Monday, June 15, 2009 11:33 AM
To Next Page
Loading...
