Dell PowerEdge T710 - Installing a Hard Drive into a Hard-Drive Carrier

Installing System Components 93
Installing a Hard Drive Into a Hard-Drive Carrier
1 Insert the hard drive into the hard-drive carrier with the connector end
of the drive at the back. See
Figure 3-8 .
2 Align the screw holes on the hard drive with the set of holes on the hard-
drive carrier.
When aligned correctly, the back of the hard drive will be flush with the
back of the hard-drive carrier.
3 Attach the four screws to secure the hard drive to the hard-drive carrier.
Figure 3-8. Installing a Hard Drive Into a Hard-Drive Carrier
1 hard-drive carrier 2 screws (4)
3 hard drive
1
2
3
book.book Page 93 Monday, June 15, 2009 11:33 AM