Installing System Components 131
Installing the Chassis Intrusion Switch
1
Align the chassis intrusion switch with the securing bracket notch. See
Figure 3-22.
2
Slide the switch into the securing bracket notch. See Figure 3-22.
3
Connect the chassis intrusion switch cable to the connector on the system
board.
4
Close the system. See "Closing the System" on page 86.
5
Place the system upright and on its feet on a flat, stable surface.
6
Rotate the system feet outward.
7
Reattach any peripherals and connect the system to an electrical outlet.
8
Turn on the system and attached peripherals.
book.book Page 131 Monday, June 15, 2009 11:33 AM
To Next Page
Loading...
