About this guide
This guide provides site preparation recommendations, step-by-step procedures for rack mounting and desk mounting, inserting
modules, and connecting to a power source.
CAUTION: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this
equipment.
NOTE: Only trained and qualified personnel can install this equipment. Read this guide before you install and power up this
equipment. This equipment contains two power cords. Disconnect both power cords before servicing.
NOTE: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.
Figure 1. Class 1 laser product tag
NOTE: When no cable is connected, visible and invisible laser radiation may be emitted from the aperture of the optical
transceiver ports. Avoid exposure to laser radiation. Do not stare into open apertures.
NOTE: Read this guide before unpacking the switch. For more information, see Unpack the switch.
Topics:
• Related documents
• Information symbols
Related documents
For more information about the S4100-ON Series, see the following documents:
● Dell SmartFabric OS10 Release Notes
● Dell SmartFabric OS10 User Guide
● Dell S4100-ON Series Setup Guide
● Dell Open Networking Hardware Diagnostic Guide
● S4100-ON Series Release Notes
NOTE:
To access product documentation and resources that might be helpful to install, configure, and troubleshoot the
specific Dell PowerSwitch, see the Dell Networking OS10 Info Hub. For all other resources, see Dell support: www.dell.com/
support.
Information symbols
This book uses the following information symbols:
NOTE: The Note icon signals important operational information.
1
About this guide 5
To Next Page
Loading...
Need help?
General
