Steps
1. Insert the hard drive assembly into the slot on the system.
2. Slide the hard drive assembly towards the connector in the system board until the release tabs clicks into place.
Next steps
1. Install the front bezel.
2. Install the top cover (side bezel).
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Disk SSD
Removing the M.2 2280 PCIe solid-state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
Demontáž a opětovná montáž
35
To Next Page
Loading...
