Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the fan assembly.
2. Install the front bezel.
3. Install the top cover (side bezel).
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
Karta expandéru
Removing the riser card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the top cover (side bezel)
4. Remove the front bezel.
5. Remove the fan assembly.
NOTE: This step is valid for system configuration that is shipped with 80 W CPU.
About this task
The following images indicate the location of the riser card and provide a visual representation of the removal procedure.
Demontáž a opětovná montáž
47
To Next Page
Loading...
