Dell Precision 3240 Compact - Interposer Module Removal and Installation

Modul mezikusu
Removing the interposer module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the top cover (side bezel)
4. Remove the front bezel.
5. Remove the fan assembly.
NOTE: This step is valid for system configuration that is shipped with 80 W CPU.
6. Remove the riser card.
About this task
The following images indicate the location of the interposer module and provide a visual representation of the removal procedure.
Steps
1. Flip open the actuator and disconnect the SATA FPC cable from the system board.
2. Loosen and remove the single screw (M3x5) securing the interposer module to the system board.
Installing the interposer module
Prerequisites
Jestliže nahrazujete určitou součástku, vyjměte před montáží stávající součástku.
About this task
The following image indicates the location of the interposer module and provides a visual representation of the installation procedure.
60
Demontáž a opětovná montáž