13. Install the SSD door.
14. Install the SD card.
15. Follow the procedure in after working inside your computer.
Polssteun
Removing the palmrest
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the SSD door.
4. Remove the secondary M.2 SSD.
5. Remove the base cover.
6. Remove the battery.
7. Remove the primary M.2 SSD.
8. Remove the SIM card.
9. Remove the secondary memory.
10. Remove the WWAN card.
11. Remove the WLAN card.
12. Remove the keyboard lattice.
13. Remove the keyboard.
14. Remove the primary memory.
15. Remove the power adapter port.
16. Remove the power button board.
17. Remove the smart card reader.
18. Remove the touchpad buttons.
19. Remove the SD card reader.
20. Remove the power button. or power button assembly with fingerprint reader
21. Remove the heat-sink assembly.
22. Remove the inner frame.
23. Remove the GPU power cable.
24. Remove the GPU card.
25. Remove the system board.
26. Remove the speaker.
27. Remove the middle cap.
28. Remove the display assembly.
About this task
The picture below shows the palmrest after performing the pre-removal parts procedures for any palm rest replacement
Demonteren en hermonteren
79
To Next Page
Loading...
