3–Adapter Management Applications
Windows Management Applications
103 CU0354602-00 L
Windows Diagnostic Test Messages
If a test fails, an appropriate error code is generated and displayed, as shown in
Table 3-9. Note that this table does not list error messages for the Interrupt and
Link tests.
Table 3-9. Windows Diagnostic Test Messages
Test Error Message Description
Loopback LB_TEST_OK Loopback test has passed
Loopback
LB_SEND_WAIT_QUEUE_ERR
Send queue blocked
Loopback LB_NORCV_ERR Receive packet not received
Loopback LB_NOMEM_ERR No memory error
Loopback LB_TX_QUEUE_ERR Transmit queue error
Loopback LB_SHORT_DATA_ERR Looped data short error
Loopback LB_SEQUENCE_ERR Looped data out of sequence
Loopback LB_DATA_ERR Looped data corrupted
Loopback LB_ERR_CNT Looped error count
Register CR_TEST_OK Control register test passed
Register CR_NIU_MODE Network interface unit (NIU) error
Register CR_PHY Physical layer (PHY) error
Register CR_ERRCNT Control register error count
Hardware HW_TEST_OK Hardware test has passed
Hardware HW_DMA_BZ_0 DMA channel 0 is busy
Hardware HW_DMA_BZ_1 DMA channel 1 is busy
Hardware HW_DMA_BZ_2 DMA channel 2 is busy
Hardware HW_DMA_BZ_3 DMA channel 3 is busy
Hardware HW_SRE_PBI_HALT Segmentation and reassembly engine currently halted
Hardware HW_SRE_L1IPQ Segmentation and reassembly engine currently paused
due to L1 IPQ discard failure
Hardware HW_SRE_L2IPQ Segmentation and reassembly engine currently paused
due to L2 IPQ discard failure
Hardware HW_SRE_FREEBUF Segmentation and reassembly engine free buffer list is cur-
rently empty.
Hardware HW_IPQ IPQ is currently not empty
To Next Page
Loading...