Dell QMD8262-k

5–Boot Configuration
Dell System Setup
181 CU0354602-00 L
Dell System Setup
The Dell System Setup allows you to configure a network adapter. The System
Setup contains the following pages related to the QLogic adapter:
 System Setup Main menu (see Figure 5-1)
 Device Settings (see Figure 5-2)
 Main Configuration
Device and Firmware Image Information
NIC Partitioning (Switch Independent Partitioning)
Configuration
Global Bandwidth Allocation
Partition 1 Configuration
Partition 2 Configuration
Partition 3 Configuration
Partition 4 Configuration
NIC Configuration
iSCSI Configuration
iSCSI General Parameters
iSCSI Initiator Parameters
iSCSI First Target Parameters
iSCSI Second Target Parameters
FCoE Configuration
The first three pages are used to access the Dell System Setup, select the QLogic
adapter, and access the adapter’s Main Configuration page. This page provides
access to all available configuration options for the selected adapter.