4–Switch Independent Partitioning
Switch Independent Partitioning Setup and Management Options
158 CU0354602-00 L
f. Specify whether you want your bandwidth settings to persist across
reboots (see Figure 4-23).
Figure 4-23. Setting Bandwidth Changes to Persist
6. Return to the NIC Partitioning <NPAR> Configuration Selection screen.
7. Change the personalities of each function to meet your system
requirements. For example:
a. Select 2: Change PCI Function Personality.
b. Select the port number, 1 or 2.
c. Select the function number.
The command line displays a list of options with choices that apply to
the selected function number. This mode prevents you from assigning
a function type that does not apply to a given function number.
d. Set the personality type by selecting the option number that identifies
the appropriate function type. Depending on the function number and
current state, this could be Disabled, NIC, FCoE, or iSCSI.
For a list of Switch Independent Partitioning configuration options, see
“Switch Independent Partitioning Setup” on page 172.
To Next Page
Loading...