Dell QMD8262-k

5–Boot Configuration
iBFT Boot Setup
217 CU0354602-00 L
2. Select System BIOS Settings, then select Boot Settings, then select BIOS
Boot Settings, and then select Hard-Disk Drive Sequence, as shown in
Figure 5-34.
Figure 5-34. Selecting iSCSI Boot Sequence
3. In the pop-up window, use the UP ARROW and DOWN ARROW or
the + and – buttons to move the iSCSI target to the top of the list, as
shown in Figure 5-35 (where the iSCSI target is configured on Port 1,
Partition 3). Then click OK.
Figure 5-35. Setting the iSCSI Boot Sequence