Dell S4810 - Install the System into a Two-Post Rack or Cabinet

20 | Install the S4810
www.dell.com | support.dell.com
Install the System into a Two-Post Rack or Cabinet
Ensure that there is adequate clearance surrounding the rack or within the cabinet to permit access and
airflow.
To install a system into a two-post 19-inch equipment rack using the already attached mounting brackets,
follow these steps:
2 Attach the brackets to the PSU sides of the system using four screws for each bracket. Attach the bracket so that
the “ear” is parallel to the PSU and the outside of the system.
Step Task
NOTE: Dell Force10 recommends using one person to hold the S4810 chassis in place while
another person attaches the brackets to the posts.
Step Task (continued)
View from chassis I/O side
View of chassis PSU side
Power Supply
Screws
Screws
Connect to
Rack/Cabine
t
(ears)
Connect to
Rack/Cabinet
(ears)