Install the S4810 | 21
Attach the Mounting Brackets into a Four-Post Rack or Cabinet
The S4810 is shipped with mounting brackets (rack ears) and the required screws for a two-post rack or
cabinet installation. To install the S4810 in a four-post rack or cabinet, you must order additional brackets
separately (Catalog # SA-01-RMB-06). Use the brackets included with the S4810 on the I/O side of
system and use the brackets you ordered separately on the PSU side of the system.
Unlike the two-post installation, the four-post installation requires attaching brackets to the rack prior to
installing the system.
To attach the brackets to the rack or cabinet, follow these steps:
3 Attach the bracket “ears” to the rack or cabinet posts using the two screws for each bracket. Ensure the screws are
tightened firmly.
Step Task
1 Ensure that there is adequate clearance surrounding the rack or within the cabinet to permit access and airflow.
2 Take the brackets and screws out of their packaging.
Step Task (continued)
PSU0
PSU1
Rack/Cabine
Post
Rack Mounting
Ears
To Next Page
Loading...
