Dell S4810 - Supply Power and Power up the System

Install the S4810 | 29
Figure 4-4. Three S4810s Connected in a Ring
Supply Power and Power Up the System
Supply power to the S4810 after it is mounted in a rack or cabinet.
Dell Force10 recommends re-inspecting your system prior to powering up. Verify that:
• the equipment is properly secured to the rack and properly grounded.
• the equipment rack is properly mounted and grounded.
• the ambient temperature around the unit (which may be higher than the room temperature) is within the
limits specified for the S4810.
• there is sufficient airflow around the unit.
• the input circuits are correctly sized for the loads and that you use sufficient over-current protection
devices.
• all protective covers are in place.
• blank panels are installed if you do not install optional modules.
. NOTE: A US AC power cable is included for powering up an AC power supply. You must order all other
power cables separately.
. WARNING: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or
heel ground strap when handling the S4810 and its components.
52 60
52 60
52 60
48 56
48 56
48 56
Chassis 3
Chassis 2
Chassis 1