Console Ports | 39
7
Console Ports
You can access the S4810 directly through the console port at the Input/Output (I/O) side of the system.
Access the RJ-45 Console Port (RS-232)
NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on
your PC.
The RS-232/RJ-45 console port is labeled on the upper-right-hand side of the S4810 chassis (the I/O side)
(
Figure 7-1
).
Table 7-1
lists the console port pinout assignments.
Figure 7-1. S4810 Serial Console Port Connector
To access the console port, follow these steps:
Step Task
1 Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S4810 console port to a
terminal server.
2 Connect the other end of the cable to the Dumb Terminal Emulator (DTE) server.
3 Keep the default terminal settings on the console as follows:
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
RJ-45
Console Port
To Next Page
Loading...
