Dell S4810 Installing Guide

Specifications | 41
8
Specifications
This chapter contains the following sections:
• Chassis Physical Design
• Agency Compliance
Chassis Physical Design
Environmental Parameters
AC Power Requirements
Parameter Specifications
Height 1.73 inches (4.4 cm)
Width 17.32 inches (44.0 cm)
Depth 18.74 inches (47.6cm)
Chassis weight with factory-installed components 14.41 pounds (approx.) (6.54 kg)
Rack clearance required Front: 5-inches (12.7 cm)
Rear: 5-inches (12.7 cm)
Thermal dissipation 921 BTH/h (270W)
Power consumption 230 Watts (nominal)
270 Watts (maximum)
Parameter Specifications
Temperature 32° to 104°F (0° to 40°C)
-40° to 158°F (-20° to 70°C)
Maximum altitude No performance degradation to 10,000 feet (3,048 meters)
Relative humidity 10 to 85% non-condensing
Shock MIL-STD-810
Parameter Specifications
Nominal input voltage 100 to 240 VAC, 47-63 Hz
Maximum AC power supply input current 4.20 A @ 100VAC
1.70 A @ 240 VAC
Maximum system power input 350 W

Dell S4810 Specifications

General

Ports	48 x 10GbE SFP+
Uplink Ports	4 x 40GbE QSFP+
Switching Capacity	1.28 Tbps
Rack Units	1U
Product Type	Switch
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Yes
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Power Supply	Dual, hot-swappable
MAC Address Table Size	128, 000 entries
Routing Protocol	OSPF, BGP, RIP, PIM, VRRP
Remote Management Protocol	SNMP
Features	VLAN, QoS
Humidity	10% to 90% non-condensing
Dimensions (WxDxH)	43.9 x 46.5 x 4.3 cm