Dell SE2425H - Keypad Board; Removing the Keypad Board

Disassembly and reassembly 17
Next steps
1. Install the VESA cover.
2. Install the stand.
3. Follow the procedure in After working inside your monitor.
Keypad board
Removing the keypad board
Prerequisites
1. Follow the procedure in Before working inside your monitor.
2. Remove the stand.
3. Remove the VESA cover.
4. Remove the back cover.
Steps
1. Open the latch and disconnect the keypad cable from the connector on the interface board.
2. Remove the keypad board from the slot on the front bezel.
3. Peel the keypad cable off from the panel shielding.
Figure 15. Removing the keypad board