Connecting the cables 9
Connecting the cables
WARNING: Before you begin any of the following procedures, follow the Safety Instructions.
WARNING: Ensure that the grounded power outlet for the power cable is accessible to the operator and located close to
the equipment.
To disconnect power from the equipment, unplug the power cord from the power outlet by grasping the plug firmly.
Never pull on the cord.
WARNING: A certified power supply cord has to be used with this equipment. The relevant national installation and/ or
equipment regulations shall be considered. Use a certified power supply cord meeting IEC 60227 standards (H05VV-F
3G 0.75 mm² or H05VVH2-F2 3G 0.75 mm²). Alternatively, you can consider a synthetic rubber flexible cord.
NOTE: Do not connect all cables to the computer simultaneously. It is recommended to route the cables through the cable-
management slot before you connect them to the monitor.
NOTE: Dell monitors are designed to work optimally with Dell-supplied inbox cables. Dell does not guarantee the video quality and
performance if non-Dell cables are used.
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
2. Connect VGA or HDMI cable from your monitor to the computer.
Connecting VGA cable
Figure 6. Connecting VGA cable
Connecting HDMI cable
Figure 7. Connecting HDMI cable
5
To Next Page
Loading...
