Setting up the monitor | 41
Setting up the monitor
Attaching the stand
NOTE: The stand is not installed at the factory when shipped.
NOTE: The following instructions are applicable only for the stand that was
shipped with your monitor. If you are attaching a stand that you purchased
from any other source, follow the setup instructions that were included
with the stand.
To attach the monitor stand:
1. Align and place the stand riser on the stand base.
2. Open the screw handle at the bottom of the stand base and turn it clockwise to
secure the stand assembly.
3. Close the screw handle.
3
1
2
To Next Page
Loading...
