Dell Thunderbolt U4025QW - OSD Warning Messages

92 | Operating the monitor
OSD warning messages
When the monitor does not support a particular resolution mode, you can see the
following message:
The current input timing is not supported by the monitor display.
Please change your input timing to 5120x2160 or any other
monitor listed timing as per the monitor specications.
The above message explains that the monitor cannot synchronize with the signal that
it is receiving from the computer. See Monitor Specifications for the Horizontal and
Vertical frequency ranges addressable by this monitor. The recommended mode is
5120 x 2160.
You can see the following message before the DDC/CI function is disabled:
The function of adjusting display setting using PC
application will be disabled.
Do you wish to disable DDC/CI function?
Yes
No
When the monitor enters the Standby Mode, the following message appears:
Going into Standby mode...
Activate the computer and wake up the monitor to gain access to the OSD.
If you press any button other than the power button, the following messages appears
depending on the selected input:
No DP Signal form your device.
Press any key on the keyboard to wake up.
If there is no display, press the monitor joystick to open
up the Menu and select the correct inport source.