Operating the monitor | 93
A message is displayed while the cable supporting DP alternate mode is connected to
the monitor under the following conditions:
• When Auto Select for Thunderbolt(140W) is set to Prompt for Multiple
Inputs.
• When the Thunderbolt
TM
cable is connected to the monitor.
Select the primary use of the monitor’s Thunderbolt connection:
Display PC screen while charging
Only charge device
Always display PC screen while charging
If two or more ports are connected, when the Auto of Input Source is selected, it will
turn to the next port with signal.
Exit
DP HDMI
Thunderbolt (140W)
Auto
Select OSD items of On in Standby Mode in the Personalize feature, the following
message appears:
Changing to this setting ( without
symbol) will increase
power consumption. Do you want to continue?
Yes
No
If adjust the Brightness level above the default level over 75%, the following message
will appear:
Adjusting to this value will increase power consumpiton above the default level.
Do you want to continue?
Yes
No
• When you select Yes, the power message is displayed only once.
• When you select No, the power warning message appears again.
• The power warning message appears again only when the user does a Factory
Reset from the OSD menu.
To Next Page
Loading...
Need help?
General
