104 Removing and Installing Parts
Memory
You can increase your computer memory by installing memory modules on
the system board.
Memory Overview
• Memory modules should be installed in
pairs of matched memory size,
speed, and technology
. If the memory modules are not installed in matched
pairs, the computer will continue to operate, but with a slight reduction in
performance. See the label in the upper-right corner of the module to
determine the module’s capacity.
1 memory module
connectors (1, 2, 3, 4)
2 battery socket
(BATTERY)
3 SATA Connectors (2)
(SATA0, SATA1)
4 front panel I/O
connector
5 main power connector
(POWER)
6 SATA connectors (3)
(SATA2, SATA3,
SATA4)
7 FlexBay USB
connector (9 pins)
8 clear CMOS jumper
(RTCRST)
9 password jumper
(PSWD)
10 PCI Express x16 card
connector
11 PCI Express x8 card
connector
(x4 electrical)
12 PCI Express x1 card
connector
13 PCI card connectors 14 floppy drive connector
(FLOPPY)
15 internal USB
connector
connecting to
FlexBay device
16 rear fan connector or
card cage fan
connector
(FAN_CARD_CAGE)
17 Processor fan
connector
(FAN_CPU)
18 processor connector
19 processor power
connector
(12VPOWER)
book.book Page 104 Tuesday, November 27, 2007 10:29 AM
To Next Page
Loading...
